Hello Stu! Thank you so so much for your feedback! I will update my ports later. Thomas On 6/9/26 01:14, Stuart Henderson wrote: > On 2026/06/09 00:54, Thomas Dettbarn wrote: >> + >> +*** WARNING *** You might need to recompile the kernel. >> +Some devices have problems when they are accessed through uftdi(4). One >> +of the ways to disable them for this module is by commenting out their >> +USB IDs in /usr/src/sys/dev/usb/uftdi.c. Like so: >> + > configuring the kernel via the bsd.re-config(5) mechanism would > usually be the most convenient way to do this and I think I would > avoid suggesting other methods. basically you would want to add > the disable line to /etc/bsd.re-config, run /usr/libexec/reorder_kernel, > and reboot. > > Nice! I did not know about this method. I will try it, if it works, then I will update the README. UNFORTUNATELY, with my setup, I encountered a problem where I need this module, albeit not for loading the FPGA board itself: A second USB device I had (Which I used for UART communication with my design) did not work with ugen(4). So removing uftdi(4) completely was too much, I needed to be more precise. Hence my suggestion with the kernel patch.
No comments:
Post a Comment