On 2018-02-28 06:51, Stefan Sperling wrote:
> On Tue, Feb 27, 2018 at 04:53:06PM -0700, j@bitminer.ca wrote:
....
>
> My x130e has no problems booting -current miniroot62.fs from USB.
> Video works fine ("ATI Radeon HD 6310"). dmesg below.
>
> Did you boot from OpenBSd powered-off state or soft reboot after
> running
> Windows? It's possible that Windows leaves devices in a state where
> OpenBSD cannot use them.
>
> BTW this machine used to be an E-450 as well, however something broke
> on the mainboard so the system would not see the battery anymore.
> At the time I could only find an E-300 mainboard to replace it but it's
> been working fine since.
Just for laughs I booted an OpenBSD 4.2 CD, circa 1997 (and five years
older than the hardware) and while it recognized few devices it did show
all video correctly. The video device vga1 shows as vendor "ATI"
unknown product 0x9806 rev 0x00.
Thanks for the hint on power cycling; however I always have had to
restart from power off to get the choice of boot device.
And here is another hint: after booting with "-c" the screen goes blank
even before the UKC> prompt.
I will try -current next.
--John
>
> OpenBSD 6.2-current (RAMDISK_CD) #11: Tue Feb 27 17:20:47 MST 2018
>
> deraadt@amd64.openbsd.org:/usr/src/sys/arch/amd64/compile/RAMDISK_CD
> real mem = 3849388032 (3671MB)
> avail mem = 3728969728 (3556MB)
> mainbus0 at root
> bios0 at mainbus0: SMBIOS rev. 2.6 @ 0xf9d00 (58 entries)
> bios0: vendor LENOVO version "8RET52WW (1.15 )" date 11/15/2011
> bios0: LENOVO 305162G
> acpi0 at bios0: rev 4
> acpi0: tables DSDT FACP SLIC HPET APIC MCFG UEFI UEFI SSDT SSDT UEFI
> acpimadt0 at acpi0 addr 0xfee00000: PC-AT compat
> cpu0 at mainbus0: apid 0 (boot processor)
> cpu0: AMD E-300 APU with Radeon(tm) HD Graphics, 1297.51 MHz
> cpu0:
> FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,APIC,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,CFLUSH,MMX,FXSR,SSE,SSE2,HTT,SSE3,MWAIT,SSSE3,CX16,POPCNT,NXE,MMXX,FFXSR,PAGE1GB,RDTSCP,LONG,LAHF,CMPLEG,SVM,EAPICSP,AMCR8,ABM,SSE4A,MASSE,3DNOWP,IBS,SKINIT,ITSC
> cpu0: 32KB 64b/line 2-way I-cache, 32KB 64b/line 8-way D-cache, 512KB
> 64b/line 16-way L2 cache
> cpu0: 8 4MB entries fully associative
> cpu0: DTLB 40 4KB entries fully associative, 8 4MB entries fully
> associative
> cpu0: apic clock running at 199MHz
> cpu0: mwait min=64, max=64, IBE
> cpu at mainbus0: not configured
> ioapic0 at mainbus0: apid 2 pa 0xfec00000, version 21, 24 pins
> , remapped to apid 2
> acpiprt0 at acpi0: bus 0 (PCI0)
> acpiprt1 at acpi0: bus -1 (PB4_)
> acpiprt2 at acpi0: bus 1 (PB5_)
> acpiprt3 at acpi0: bus 2 (PB6_)
> acpiprt4 at acpi0: bus 3 (PB7_)
> acpiprt5 at acpi0: bus 4 (P2P_)
> acpiprt6 at acpi0: bus -1 (SPB0)
> acpiprt7 at acpi0: bus -1 (SPB1)
> acpiprt8 at acpi0: bus -1 (SPB2)
> acpiprt9 at acpi0: bus -1 (SPB3)
> acpiec0 at acpi0
> acpicpu at acpi0 not configured
> acpitz at acpi0 not configured
> "PNP0C0C" at acpi0 not configured
> "PNP0C0E" at acpi0 not configured
> "LEN0026" at acpi0 not configured
> "LEN0068" at acpi0 not configured
> "ACPI0003" at acpi0 not configured
> "PNP0C0A" at acpi0 not configured
> "PNP0C0D" at acpi0 not configured
> "PNP0C14" at acpi0 not configured
> "PNP0C14" at acpi0 not configured
> "PNP0C14" at acpi0 not configured
> pci0 at mainbus0 bus 0
> pchb0 at pci0 dev 0 function 0 "AMD AMD64 14h Host" rev 0x00
> vga1 at pci0 dev 1 function 0 "ATI Radeon HD 6310" rev 0x00
> wsdisplay1 at vga1 mux 1: console (80x25, vt100 emulation)
> "ATI Radeon HD 6310 HD Audio" rev 0x00 at pci0 dev 1 function 1 not
> configured
> ppb0 at pci0 dev 5 function 0 "AMD AMD64 14h PCIE" rev 0x00: msi
> pci1 at ppb0 bus 1
> rtwn0 at pci1 dev 0 function 0 "Realtek 8188CE" rev 0x01: msi
> rtwn0: MAC/BB RTL8188CE, RF 6052 1T1R, address 9c:b7:0d:e1:11:6d
> ppb1 at pci0 dev 6 function 0 "AMD AMD64 14h PCIE" rev 0x00: msi
> pci2 at ppb1 bus 2
> alc0 at pci2 dev 0 function 0 "Attansic Technology L1D" rev 0xc0: msi,
> address 04:7d:7b:31:00:6e
> atphy0 at alc0 phy 0: AR8035 10/100/1000 PHY, rev. 0
> ppb2 at pci0 dev 7 function 0 "AMD AMD64 14h PCIE" rev 0x00: msi
> pci3 at ppb2 bus 3
> rtsx0 at pci3 dev 0 function 0 "Realtek RTS5209 Card Reader" rev 0x01:
> msi
> sdmmc0 at rtsx0: 4-bit, dma
> ahci0 at pci0 dev 17 function 0 "ATI SBx00 SATA" rev 0x00: apic 2 int
> 19, AHCI 1.2
> ahci0: port 0: 3.0Gb/s
> scsibus0 at ahci0: 32 targets
> sd0 at scsibus0 targ 0 lun 0: <ATA, SanDisk SDSSDP12, 2.0.> SCSI3
> 0/direct fixed naa.5001b4496652afc1
> sd0: 122104MB, 512 bytes/sector, 250069680 sectors, thin
> ohci0 at pci0 dev 18 function 0 "ATI SB700 USB" rev 0x00: apic 2 int
> 18, version 1.0, legacy support
> ehci0 at pci0 dev 18 function 2 "ATI SB700 USB2" rev 0x00: apic 2 int
> 17
> usb0 at ehci0: USB revision 2.0
> uhub0 at usb0 configuration 1 interface 0 "ATI EHCI root hub" rev
> 2.00/1.00 addr 1
> ohci1 at pci0 dev 19 function 0 "ATI SB700 USB" rev 0x00: apic 2 int
> 18, version 1.0, legacy support
> ehci1 at pci0 dev 19 function 2 "ATI SB700 USB2" rev 0x00: apic 2 int
> 17
> usb1 at ehci1: USB revision 2.0
> uhub1 at usb1 configuration 1 interface 0 "ATI EHCI root hub" rev
> 2.00/1.00 addr 1
> "ATI SBx00 SMBus" rev 0x42 at pci0 dev 20 function 0 not configured
> "ATI SBx00 HD Audio" rev 0x40 at pci0 dev 20 function 2 not configured
> "ATI SB700 ISA" rev 0x40 at pci0 dev 20 function 3 not configured
> ppb3 at pci0 dev 20 function 4 "ATI SB600 PCI" rev 0x40
> pci4 at ppb3 bus 4
> pchb1 at pci0 dev 24 function 0 "AMD AMD64 14h Link Cfg" rev 0x43
> pchb2 at pci0 dev 24 function 1 "AMD AMD64 14h Address Map" rev 0x00
> pchb3 at pci0 dev 24 function 2 "AMD AMD64 14h DRAM Cfg" rev 0x00
> pchb4 at pci0 dev 24 function 3 "AMD AMD64 14h Misc Cfg" rev 0x00
> pchb5 at pci0 dev 24 function 4 "AMD AMD64 14h CPU Power" rev 0x00
> pchb6 at pci0 dev 24 function 5 "AMD AMD64 14h Reserved" rev 0x00
> pchb7 at pci0 dev 24 function 6 "AMD AMD64 14h NB Power" rev 0x00
> pchb8 at pci0 dev 24 function 7 "AMD AMD64 14h Reserved" rev 0x00
> usb2 at ohci0: USB revision 1.0
> uhub2 at usb2 configuration 1 interface 0 "ATI OHCI root hub" rev
> 1.00/1.00 addr 1
> usb3 at ohci1: USB revision 1.0
> uhub3 at usb3 configuration 1 interface 0 "ATI OHCI root hub" rev
> 1.00/1.00 addr 1
> isa0 at mainbus0
> pckbc0 at isa0 port 0x60/5 irq 1 irq 12
> pckbd0 at pckbc0 (kbd slot)
> wskbd0 at pckbd0: console keyboard, using wsdisplay1
> umass0 at uhub0 port 1 configuration 1 interface 0 "vendor 0x090c
> product 0x1000" rev 2.00/10.00 addr 2
> umass0: using SCSI over Bulk-Only
> scsibus1 at umass0: 2 targets, initiator 0
> sd1 at scsibus1 targ 1 lun 0: <, , > SCSI0 0/direct removable
> serial.090c1000083153020039
> sd1: 3801MB, 512 bytes/sector, 7784448 sectors
> "Image Processor Integrated Camera" rev 2.00/41.64 addr 2 at uhub1
> port 5 not configured
> "Broadcom Corp Broadcom Bluetooth Device" rev 2.00/7.48 addr 2 at
> uhub2 port 4 not configured
> softraid0 at root
> scsibus2 at softraid0: 256 targets
> root on rd0a swap on rd0b dump on rd0b
No comments:
Post a Comment