On Tue, Jun 25, 2019 at 12:06:51AM +0300, 3 wrote:
> i know that wifi adapters never worked in obsd(excluding those
> adapters for which drivers were written by vendors), but i found one
> that shows signs of life in 11n(11ac 2t2r supported by chip). it can
> be bought anywhere where there are samsung tv. moreover it even works
> in hostap mode(unlike the buggy athn).
> but without a ton of bugs not done:
> bwfm0: could not read register: TIMEOUT
> bwfm0: could not open rx pipe: IN_USE
> bwfm0: could not init bus
> bwfm0: firmware did not start up
> .and sometimes kernel panic on boot, but works would still!
> meet https://wikidevi.com/wiki/Samsung_WCH730B
> bwfm0 at uhub0 port 1 configuration 1 interface 0 "Broadcom BCMUSB 802.11 Wireless Adapter" rev 2.10/0.01 addr 2
> photo without cover: http://pichost.org/images/2019/06/24/Untitled-138.jpg
> it is shown where to solder the wires for wifi. on the right through
> two pins(ground is first) is bluetooth, but for obsd this does not
> matter(thx theo).
> data sheet for chip: https://www.cypress.com/file/310246/download
Did you solder that yourself? As long as nothing has changed, bwfm(4)
on USB worked fine with the one USB one that I had: The official
raspberry Pi USB WiFi stick that they sold before they put the WiFi
chip onto the board itself. I wouldn't blame that on the driver.
Did you try the stick with Linux? If it works with Linux then maybe
it's my fault after all.
Patrick
No comments:
Post a Comment