On Wed, Feb 17, 2021 at 02:05:27PM +0100, Raimo Niskanen wrote:
> On Wed, Feb 17, 2021 at 12:36:57PM +0100, Stefan Sperling wrote:
> > On Wed, Feb 17, 2021 at 12:08:52PM +0100, Raimo Niskanen wrote:
> > > Hello misc!
> > >
> > > I have problem booting an APU2 from SD card and USB stick.
> > > It boots fine from the mSATA disk where I have the OpenBSD installation
> > > that I have upgraded several times using sysupgrade(8).
> > >
> > > I have tried to write install67.fs and install68.img to an SD card and to
> > > an USB stick from a Linux machine using e.g
> > > dd if=install67.fs of=/dev/sdc bs=1M
> > >
> > > On the APU:s serial console, I press [F10] to get a boot prompt, and then
> > > select the SD card or the USB stick. The kernel is loaded and the last
> > > printout is "Entry point: 0xffff..." something. The next line
> > > [ELF ... whatnot] does not come. After a while the APU resets and boots
> > > again, or sometimes hangs.
> >
> > Before loading a kernel the serial console needs to be enabled with:
> >
> > stty com0 115200
> > set tty com0
> >
> > On an installed system /etc/boot.conf is usually set up to do this
> > automatically but manual setup is still required when booting from
> > other media.
>
> Oh, bummer! Of course. I hope it is such a stupid mistake!
> I will try when I get a new opportunity...
>
> Thank you very much.
Confirmed. It was nothing more than that silly beginner's mistake.
Than you for the cluestick!
--
/ Raimo Niskanen, Erlang/OTP, Ericsson AB
No comments:
Post a Comment