I followed the documented procedure (https://www.openbsd.org/arm64.html
and https://ftp.openbsd.org/pub/OpenBSD/7.0/arm64/INSTALL.arm64) for
installing on Raspberry Pi 400 systems:
- put install70.img on a USB stick
- boot from UEFI firmware v1.21 on a microSD card
- `set tty fb0`
- boot installer
The installer boots, but only halfway. The usual blue text scrolls past
but then it reboots midway through. This happens too quickly for me to
see the error message immediately preceeding the reboot.
Any suggestions for troubleshooting? I am working on getting a serial
adapter so I can log the boot messages.
No comments:
Post a Comment