El lun, 28 feb 2022 a las 18:12, <tetrahedra@danwin1210.de> escribió:
>
> I followed the documented procedure (https://www.openbsd.org/arm64.html
> and https://ftp.openbsd.org/pub/OpenBSD/7.0/arm64/INSTALL.arm64) for
> installing on Raspberry Pi 400 systems:
>
> - put install70.img on a USB stick
> - boot from UEFI firmware v1.21 on a microSD card
> - `set tty fb0`
> - boot installer
>
> The installer boots, but only halfway. The usual blue text scrolls past
> but then it reboots midway through. This happens too quickly for me to
> see the error message immediately preceeding the reboot.
>
> Any suggestions for troubleshooting? I am working on getting a serial
> adapter so I can log the boot messages.
>
Just for the sake of curiosity:
With a cellphone at hand, you could get a cue recording the full boot
sequence and playing it frame by frame a couple of times.
No comments:
Post a Comment