On Thu, Jun 30, 2022 at 03:11:18PM -0700, Courtney wrote:
> Hello everyone,
>
> I am running OpenBSD -current branch right now. I have a FiiO E10k plugged
> into my board. Here is the part of the dmesg when it is connected
>
> Jun 30 15:02:48 towerDefense /bsd: uaudio0 at uhub0 port 14 configuration 1
> interface 2 "FiiO DigiHug USB Audio" rev 1.10/0.01 addr 6
> Jun 30 15:02:48 towerDefense /bsd: uaudio0: class v1, full-speed, sync,
> channels: 2 play, 2 rec, 3 ctls
> Jun 30 15:02:48 towerDefense /bsd: audio1 at uaudio0
>
> I have been trying to pinpoint an issue where after a time of being away
> from my computer,
> when I come back my audio isn't behaving. I'm not an audio guy so I will
> probably mess
> up some terms, sorry. The pitch sounds right but the audio has a lot of
> static in it. Normally
> this happens after I walk away from my computer and come back maybe an hour
> later. It
> doesn't go into any sleep state, only power efficiency mode that the
> monitors handle on their
> own. An rcctl restart sndiod doesn't solve the issue, I have to physically
> unplug and plug it,
> then run rcctl restart sndiod and all is back to normal. Nothing appears in
> the logs for me
> to report. What can I look at when I encounter this again to see what is
> being changed
> (if anything)? Or, maybe my hardware is just progressively giving up the
> ghost? This has been
> happening for a while now.
When you walk away is it playing? you can run:
audioctl -f /dev/audioctl1
to check device state before and after the walk (empty "mode" means
it's closed, "pause=0" means it's playing or recording)
No comments:
Post a Comment