Re: [NEW] cad/xnec2c

On 2026/01/05 15:21, Enzo Nicosia wrote:
> On Tue, Dec 30, 2025 at 11:36:32AM +0000, Stuart Henderson wrote:
> > tgz with tweaks attached;
> >
>
> Hello Stuart, and thanks again.
>
> > - don't use github autogenerated tar when upstream has an uploaded one
>
> OK.
>
> > - use standard location for examples (I couldn't figure out where
> > install is done in the makefiles to adjust directly, so just mv'd
> > into place)
>
> I guuess your solution of mobing them in place in post-install is best,
> as the patches to the Makefile.am could be cumbersome and error-prone
> (upstream maintains a list of examples that are allowd with the current
> version, appaarently).
>
> > - don't list ports as LIB_DEPENDS unless they're used directly
> > (e.g. libraries only used as deps of gtk+3)
>
> got that, thanks.
>
> > - small ordering/whitespace tweaks
> >
>
> Those are fine by me. Can I ask if there is a specific reason for having
> space rather than TAB after WANTLIB += ? I think I had used TAB
> consistently for all the other variables (I get and accept your point
> about aligning and ordering, thanks), but I wonder if WANTLIB is somehow
> different? Or += is somehow different? Sorry if I am missing something
> moot here.

we usually copy and paste these from "make port-lib-depends-check"
without reformatting

> New tgz attached. It is the same you sent me, where I have removed
> Makefile- (the old Makefile).
>
> Is this OK?

ok with me if someone would like to import