On Wed, Jun 30, 2021 at 07:45:13AM -0400, George wrote:
> Hi thanks for the reply! How is the performance on the 200nx are you using
> it as an access point i.e. router? How many antennas?
There is currently no way to run an AP on OpenBSD if you require performance
levels comparable to commercially available access points.
Regarding athn(4) in particular, there is no support for Tx aggregation and
there are unresolved bugs which prevent Tx rates at the upper end from working.
You can expect about 20 Mbit/s top, most likely less than that.
But it is fairly stable. If performance isn't your main concern it can be fine.
athn(4) only supports 2 antenna cards. Cards with 3 anntennas don't work yet.
If you can only connect one antenna you need to run this command to prevent
packet loss: ifconfig athn0 nwflag nomimo
No comments:
Post a Comment